Greasing The Windrower Tractor - MacDon 9250 Operator's Manual

Greasing the Windrower Tractor

See "Fuels, Fluids and Lubricants" for recom-
mended greases.
The following greasing points are marked on the
windrower by decals showing a grease gun (A),
and grease interval (B) in hours of operation. Use
the engine hour meter in the cab and the
"Maintenance Checklist" provided to keep a record
of scheduled maintenance.
Procedure:
1. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
2. Inject grease through fitting with grease gun
until grease overflows. Inject grease slowly to
prevent seal damage.
3. Leave excess grease on fitting to keep out dirt.
4. Replace any loose
immediately.
5. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
6. Store grease gun on tractor frame at (C).
DANGER: Stay clear of drivelines
until all movement has stopped.
Entanglement with rotating driveline
will cause serious personal injury or death.
Avoid loose fitting or dangling clothing.
10 Hours
TRANSMISSION DRIVELINE SLIP JOINT (E) -
ONE FITTING
50 Hours
NOTE: For Harvest Header, there are two more 10
Hour fittings on driveline connector shaft.
Form # 46584
MAINTENANCE/SERVICE
or broken fittings
E
SAMPLE GREASE DECAL
C
GREASE GUN STORAGE
STAY CLEAR OF ROTATING DRIVELINES
DRIVELINE (D) - FIVE FITTINGS
(2 CROSSES, 1 SHAFT, 2 SHIELD)
61
D
Issue 11/06 Web Rev_01