Table of Contents
Advertisement
Seat Belt
Inspection and Maintenance
Keep the operator and trainer seat belts in
good condition as follows:
1. Keep sharp edges and items that can
cause damage away from the belts.
2. From time to time, check belts, buckles,
retractors, tethers, slack take-up system
and mounting bolts for damage.
3. Replace all parts that have damage or
wear.
4. Replace belts that have cuts that can
weaken the belt.
5. Check that bolts are tight on the seat
bracket or mounting.
6. Keep seat belts clean and dry. Clean only
with a soap solution and warm water. DO
NOT use bleach or dye on the belts, as this
may weaken the material.
Operator Presence System
Make sure the Operator Presence System is
operating as follows:
1. With the windrower engine running, place
the park brake on and the ground speed
lever in neutral.
2. With everyone clear of the machine,
engage header drive switch.
3. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
Operator
presence
adjustment. See your dealer.
NOTE: To restart the header, the operator must
move the header engage switch to "OFF" position
and back to the "ON" position again.
Form # 46584
MAINTENANCE/SERVICE
system
requires
58
R/H Step Ladder – Use & Storage
A storable ladder is provided on the right hand side
of the tractor for access to the maintenance
platform.
For storage, swing ladder up and pivot arm (A)
down as shown.
A
Issue 11/06 Web Rev_01
Advertisement
Table of Contents
Troubleshooting
