MacDon 9250 Operator's Manual page 143

Preparing 962/963 Harvest Header
for Windrower Tractor
1. Attach lift linkage supports to lower header legs
with 5/8 locknut at (A).
NOTE: For 963 Header, remove existing
linkage supports first.
2. Attach connector shaft assembly to header
frame tube as follows:
• With carriage bolt and nut installed loosely in
plate (C) of shaft assembly, engage head of
carriage bolt in key-hole slot in header frame
tube near left leg.
• Holding left side of shaft assembly slightly away
from tube, slide shaft assembly to the left, so
bolt enters narrow section of key-hole slot and
plate (D) aligns with outboard side of lug
welded to header frame tube.
• Fasten plate (D) to lug with two 3/8 x 1 inch
carriage head bolts and flange locknuts.
• Tighten nut to secure shaft assembly at plate
(C).
• Attach header driveline to outboard end of
connector shaft. Attach clamp yoke end of
driveline to header drive shaft.
3. Remove blue male coupler from draper return
hose. Add hose extension from adapter kit to
draper return hose and install coupler on end of
hose extension at (H). Route hose through
loops (J) on connector shaft as shown.
4. Move reel drive couplers mounting plate from
side of header leg to position (E) shown.
IMPORTANT: Damage to couplers may occur if
plate is not re-positioned.
Form # 46584
ASSEMBLY
ATTACH LINKAGE SUPPORTS
TO HEADER LEGS – 962/963 HEADER
ATTACH CONNECTOR SHAFT
TO HEADER FRAME TUBE &
ADD DRAPER RETURN HOSE EXTENSION
RE-POSITION REEL DRIVE COUPLERS
141
J
D
962/963 HEADER
E
962/963 HEADERS
Issue 11/06 Web Rev_01
C
H