Raymarine a67 Wi-Fi Installation And Operation Instructions Manual page 129

• Stop Goto
• Restart XTE
• Advance Waypoint
• Measure
• Build Route
• Acquire Target (only available if Radar overlay is switched
on.)
• Slew thermal camera (only available when thermal camera
is connected and operating.)
Accessing the context menu
You can access the context menu by following the steps below.
1. New e Series or New c Series:
i. Selecting a location, object or target on-screen and
pressing the Ok button.
2. Touchscreen multifunction displays:
i. Selecting an object or target on-screen.
ii. Selecting and holding on a location on-screen.
Waypoint features
There are a range of features for placing, navigating and
managing waypoints.
Waypoint features are accessed from:
• the waypoint context menu — by positioning the cursor over
an existing waypoint on the screen.
• any application — by pressing the WPT button (New c Series
and New e Series) or the WPT icon (New a Series). This
displays the Waypoints menu.
• the chart application — by going to the following menu:
Menu > My Data.
• the homescreen — by going to the following menu: My Data.
Note: Pressing the WPT button or the WPT icon from the
homescreen will open the waypoint list.
Waypoint (MOB) button / icon
Depending on the multifunction display variant there will be
either a Waypoint (MOB) button or an on-screen icon.
WPT button
WPT icons
Throughout this manual the term: Select WPT, refers to pressing
the physical WPT button or pressing the on-screen WPT icon.
Waypoint placement
Placing a waypoint
You can place a waypoint on a touchscreen multifunction
displays by following the steps below.
Waypoints, Routes and Tracks
• New c Series
• New e Series
• New a Series
D11763-2
From the chart, radar or fishfinder application:
1. Select and hold the required location on screen.
The context menu is displayed.
2. Select Place Waypoint.
Placing a waypoint
From the chart, radar or fishfinder application:
1. Position the cursor at the required position.
2. Press the WPT button.
The chart context menu is displayed.
3. Select Place Waypoint.
The waypoint is placed at the location and a confirmation
pop up message is displayed.
4. Select Ok to confirm waypoint placement, or Edit to edit the
waypoint details.
Placing a waypoint at your vessel's position
In addition to positional information, a waypoint placed at the
vessel position will capture temperature and sounded depth
information (if you have the appropriate sensors connected to
your system).
From the chart, radar or fishfinder application:
1. Select WPT.
The waypoint menu is displayed.
2. Select WPT again.
A confirmation pop up message is displayed.
3. Select Ok to place the waypoint, or Edit to edit the waypoint
details.
Note: Alternatively with the waypoint menu displayed you can
select Place Waypoint At Vessel.
Placing a waypoint at a known position
You can place a waypoint at a specified location using latitude
and longitude coordinates:
1. Select WPT.
2. Select Place Waypoint At Lat/Lon.
3. Select the Position field.
4. Enter the Latitude/Longitude position.
5. Select SAVE.
6. You can also add a name for the waypoint and add to a group
by selecting the Name and Group fields.
Navigation
Navigating to a location on the chart
From the chart application:
1. Select the required location on-screen.
The chart context menu is displayed.
2. Select Goto Cursor.
Navigating to the cursor position on the chart using the
menu
From the chart application:
1. Position the cursor at the desired destination on the chart.
2. Select Menu.
3. Select Navigate.
4. Select Goto Cursor.
D11764-2
129