Table of Contents
Advertisement
Hybrid Spot
6.6 Moulding Clip Rivet Welding
Figure 6.21
6.7 Dent Pulling with Washers and Slide Hammer with Hook
Figure 6.24
All Info Copyright © Pro Spot International Inc.
This function will weld on factory type clips for the window moulding. The clips
that hold the moulding do not, usually, come on the replacement parts.
Rivets are held in place during welding with magnetic adapter electrode.
1. Select 1 Battery in the ON position, minimum weld time.
2. Select Rivet Welding Program by pressing the Left or Right Navigation Buttons
3. Choose weld power level by pressing the "Next Program" button repeatedly.
4. Fit Single-Sided gun with the magnetic rivet adapter (fig. 6.21).
5. Insert rivet into the adapter (fig. 6.21).
6. Prepare the surface area by removing paint and primer.
7. Ground the working area (refer to section 6.1 "Single-Sided Welding
Overview").
8. Position Single-Sided gun over work area and push the trigger to weld.
9. Repeat as needed.
The slide hammer with hook (optional) can be used in conjunction with washers
to repair car body dents.
Tip: You can purchase a slide hammer with hook from your local Pro Spot
distributor or on the web at Pro Spot online store.
Astuce: Vous pouvez acheter un marteau glissant avec crochet de votre
distributeur locale Pro Spot ou sur le web à la boutique Pro Spot en ligne.
Washers are held in place during welding with magnetic adapter electrode.
1. Select 1 Battery in the ON position.
2. Fit Single-Sided gun with the magnetic washer adapter (fig. 6.24).
3. Insert washer into the adapter (fig. 6.24).
4. Prepare the dent surface area by removing paint and primer.
When welding on washers, you only need to clean the area where the washer
touches the metal since the grounding system is connected through a separate
cable.
5. Ground the working area (refer to section 6.1 "Single-Sided Welding
Overview").
6. Position the washer at the bottom of the dent and push the trigger to weld the
washer onto the metal.
7. Hook the washer with the slide hammer and pull out the dent.
8. Repeat as needed.
Tip: You can, also, pull multiple washers by welding on a row of washers
at the bottom of the dent, inserting a rod through the washers and pulling
the rod with the slide hammer with hook.
Astuce: Vous pouvez, également, tirer plusieurs rondelles par soudage sur
une rangée de rondelles au bas de la Dent, insertant une baguette par les
rondelles et en tirant la tige avec le marteau glissqnt avec crochet.
6 Single-Sided Welding
Page 29
31
Advertisement
Table of Contents
