Connect Power Supply to Vehicle Cradle
The power cable connector is L-shaped.
The long end of the L (the cable) will be facing up towards the middle strain relief cable clamp.
Align the connector pins to the vehicle cradle Power connector; firmly pushing the connector into the Power port.
Tighten the nut of the plug clockwise until the power cable is securely fastened.
Secure the cable to the cradle with the pre-installed strain relief cable clamp (see section titled Vehicle Cradle Strain Relief
Cable Clamp).
The power LED on the MX7 illuminates when it is receiving external power and an MX7 is docked.
Cradle Power Connector Port
Note:
When an external power supply is used to power this cradle, the external power supply should be UL Listed, with LPS
or Class 2 outputs rated 12V, minimum 2 Amps.
3-10
Pin Signal
Wire Color
1
Ground (CG) Green
2
Return (-)
Blue
3
+12V (+)
Brown