Cradle PWR LED
When PWR LED is ...
Off
Green
B1 and B2 LED
When B1 and/or B2 LED is ...
Off
Green
Red
Amber
Flashing Red
Docking and Undocking the HX3
The HX2 cradle docking bay can accommodate an HX3 with or without a rubber boot.
Remove the hip flip, arm band or voice case if used.
The HX3 is inserted in the cradle with the keypad visible and available for use.
The HX3 can be inserted and removed with one hand, or if preferred, two hands.
Do not "slam" or slide the HX3 sideways into the cradle. Do not rock the HX3 forward out of the cradle. Damage may result.
It means ....
No AC/DC power supplied to the cradle
and/or
No HX3 in the charging bay
and/or
HX3 is not properly seated in charging bay
and/or
if this is the first time the HX3 has been inserted, the HX3 is properly seated and has
not been powered On.
HX3 is On, is properly seated in the charging bay and is receiving external power
through the cradle.
It means ....
No battery
No spare battery in the battery bay(s)
or no AC power
or no AC/DC power is being applied to the cradle.
Charged
Spare battery pack fully charged.
Charging
Spare battery pack charging.
Standby
Spare battery pack temperature out of range.
Fault
Spare battery pack fault or failure.
1. Fingertip Depression
2. Side Rails
3. Bottom Rails
4. Cradle power supply connector for a docked HX3
11 - 7