Operating The Projector; Operating The Projector; Switching The Projector On; Switching The Projector Off - Digital Projection M-Vision 930 Series User Manual

Digital Projection
M-Vision 930 Series

Operating The Projector

Switching the projector on

1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
Wait until the self-test has completed and the
the projector will be in STANDBY mode.
2. Press on the remote control or
ON
blue for a few seconds while the lamp comes up to full brightness.

Switching the projector off

1. Press on the remote control or
OFF
The lamp will switch off, the indicator on the control panel will start flashing blue and the cooling fans will run for a short time until the
ON
projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector.
Rev B July 2014
STANDBY indicator on the projector control panel shows amber. The system will be off and
on the control panel to switch the projector on. The
STBY
on the control panel, then press the button again to confirm.
STBY

OPERATING THE PROJECTOR

indicator on the control panel flashes
ON
Installation and Quick-Start Guide
Notes
See also Connecting The Power
Supply
earlier in this guide.
The self-test is running when all the
LEDs on the control panel are lit.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
17