Changing The Filters; Changing The Filters - Digital Projection M-Vision 930 Series User Manual

Digital Projection
M-Vision 930 Series

Changing The Filters

The projector contains four identical replaceable filters accessible via the air inlets.
To replace the filters on the right-hand side of the projector:
1. Loosen the two screws on the cover of the air inlet and remove the cover.
3. Insert the new filters into the slots.
Rev B July 2014

CHANGING THE FILTERS

2. Pull out the old filters.
4. Reattach the cover and tighten the screws.
Installation and Quick-Start Guide
Notes
Before changing the filters,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the filters, avoid
using excessive force as this may
damage the equipment.
13