Smart Throttle; Air Conditioning Operation - Kipor Sinemaster IG6000 Operation Manual

5

.4 Smart Throttle

When the SMART thro
id le automatically when the electrical load is disconnected and returns to the
p roper speed required by the electrical load when the load is reconnected. The
e ngine speed varies according to the amount of load applied to the generator.
P lacing the smart throttle in the on position is recommended to minimize fuel
c onsumption and engine noise while in operation.
W hen the smart throttle is in the off position, the engine runs at rated load
RPM.

5.5 Air Conditioning Operation

For best res ults, the SMART throttle switch should be in the off position. Bring
the generator to a normal operating temperature before applying the air
conditioning load. Always allow a 2 minute wait period when manually cycling
an air conditioner off and on. A longer wait period may be required under
unusu ally hot weather conditions. Additionally, all other loads should be turned
o ff until the air conditioner has started and is performing normally. It is also
im portant to follow the air conditioner manufacturer's instructions for starting
a nd restarting for proper operation. Some air conditioner manufacturers offer
ttle is placed in the on position, engine speed is kept at
■When high
connected simultaneously, turn the SMART
throttle switch to the OFF position to reduce
voltage fluctuation.
■The SMART throttle system does not operate
effi ciently if the electrical appliance will be used in
a rapid on-off or low to high rpm mode.
- 24 -
electrical load appliances are