Smart Throttle - Kipor IG3000 Owner's Manual

The two L5-20 receptacles are rated at 20 amps. Should this current
be exceeded, the circuit protection device will activate and cut all
current to the receptacle. This will be indicated by the push button
popping out. Reduce the load to the receptacle and reset the circuit
protector by pushing in the button.

5.4 SMART Throttle

When the SMART throttle is placed in the on position, engine speed is kept at idle automatically when
the electrical load is disconnected and returns to the proper speed required by the electrical load when
the load is reconnected. The engine speed varies according to the amount of load applied to the
generator. Placing the smart throttle in the on position is recommended to minimize fuel consumption
and engine noise while in operation.
■Before connecting an appliance to the generator, check that it is in
good order, and that its electrical rating does not exceed that of the
generator. .
■When an electric motor is started, both the overload indicator light
and the output indicator light may go on simultaneously. This is
normal if the overload indicator light goes off after about four seconds.
If the overload indicator light stays on, consult a service center.
■When high electrical load appliances are connected simultaneously,
turn the SMART throttle switch to the OFF position to reduce voltage
fluctuation.
■ The SMART throttle system does not operate efficiently if the
electrical appliance will be used in a rapid on-off or low to high rpm
mode.
13