Overload Reset Switch; Smart Throttle - Kipor Sinemaster IG3000 Operation Manual

be exceeded, the circuit protection device will activate and cut all
current to the receptacle. This will be indicated by the push button
popping out. Reduce the load to the receptacle and reset the circuit
protector by pushing in the button.

5.4 Overload Reset Switch

Should the generator's maximum load of 25 watts be exceeded, AC power will be cut off but the
engine will stay running. Correct the overload condition and then press the overload reset switch on
the front panel. AC power will be restored immediately.
Overload Reset Switch
Ignition Module
Engine switch

5.5 SMART Throttle

Before connecting an appliance to the generator, check that it is in
good order, and that its electrical rating does not exceed that of the
generator. .
When an electric motor is started, both the overload indicator light
and the output indicator light may go on simultaneously. This is
normal if the overload indicator light goes off after about four seconds.
If the overload indicator light stays on, consult a service center.
SMART throttle switch
DC receptacle
Choke knob
13
Overload protection device
AC receptacle
Ground terminal
Fuel valve lever