Dc Power Application - Kipor Sinemaster IG6000 Operation Manual

a start capacitor as an extra cost option. The lack of a start capacitor can
cause the air conditi
g enerator. Contact your air conditioner dealer if you consistently have
p roblems starting your air conditioner with the generator.
5

.6 DC Power Application

The DC receptacle may be used for charging 12 volt automotive-type batteries
only. It is not designed to operate D
output will vary according to the position of the Smart throttle switch.
a. Connect the charging cable to the DC receptacle of the generator and then
to the battery terminals.
oner to draw too high a starting current and overload the
C motors. Output voltage is 15-3
■To prevent the possibility of creating sparks near the
battery, conn
then to the battery. Disconnect the cable first at the
battery.
■B efore connecting the charging cable to a battery that is
installed in a vehicle,
ground cable. Reconnect the vehicle's ground cable after
the charging cables are removed. This procedure will
prevent the possibility of a short circuit and
accidental contact is made between a battery terminal
and the vehicle's frame or body.
■Do not attempt to start an automobile engine with the
generator still connected to battery. The generator may
be da maged.
■Connect the positive battery terminal to the positive
charging cord. Do not reverse the charging cables or
serious damage to the generator and/or battery may
occur.
- 25 -
ect the charging cable first to the generator
disconnect the vehicle's battery
0V. DC
sparks if