Enter Time; Enter Dealer Code; Clear Dealer Program - Gemini GEM-P9600 Programming Instructions Manual

WI777D 08/00
E N T E R T I M E
( 1 2 : 0 5 A )
(Direct Entry)
DEALER CODE
••••••
(Direct Entry)
DEALER CODE
RE-ENTER
(Direct Entry)
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press the
Direct Address Program Mode for further programming or press the
resume normal keypad operation.
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode,
press the button to enter the Address Program Mode; (b) access Location 4091 (Clear Program) or 4093 (Cold
C
J
Start); (c) press and then (d) press the
SERVICE" will occur. Press the
4091 ••
GEM-RP1CAe2 Keypad
4093 ••
GEM-RP1CAe2 Keypad
Downloading Software.
L
NAPCO Security Systems
Enter Time (Press the (
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
MM=minutes (00–59). Select Am or Pm by pressing any number button,
then press
Dealer Code
Directly enter the Dealer Code, including leading zeros. Use the
through
9
J
to save.
Re-enter the Dealer Code to verify the previous code. Press
Press NEXT (
NOTE: The Dealer Code can be two or more digits (up to 6 digits).
button to exit the Dealer Program Mode. A "SYSTEM TROUBLE/E09-00
C
button to silence the keypad.
C
Clear Dealer Program (Erases Dealer Program)
Access address 4091, then press the
NOTE: Enter Easy Menu Driven Program Mode to program system again.
Cold Start (Erases Entire Program)
Access address 4093, then press the
NOTE: Some features (schedules) can only be programmed again with the
) button to set cursor.)
A
J
once again to save.
buttons. NOTE: Press the
) button to proceed.
E
button once again to end all programming and
C
This erases the dealer program. Use this feature to start a
customized default program. Program Data and System
Status Memory is erased where Scheduled Data and Zone
Descriptions are maintained.
This erases the entire program including Program Data,
Zone Description Data, System Status Data, Schedule Data
and Foreign Language configuration(similar to a new
panel).
X
GEM-P9600 Programming Instructions
button for a zero. Press
0
button to enter the
C
J
button. Data entry is not allowed.
J
button. Data entry is not allowed.
!
Page 13
1
J
to save.