Enter Date; Enter Time; Enter Dealer Code; Enter Dealer Program - Gemini GEM-P9600 Programming Instructions Manual

WI777D 08/00
DATE
07/18
/96
(Direct Entry)
TIME
09:10A
(Direct Entry)
(Direct Entry)
(Direct Entry)
(Direct Entry)
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press the C button to enter the
Direct Address Program Mode for further programming or press the C button once again to end all programming
and resume normal keypad operation.
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program
Mode, press the button to enter the Address Program Mode; (b) access Location 4091 (Clear Program) or 4093
C
J
(Cold Start); (c) press
Condition will occur. Press the
L
NAPCO Security Systems
Enter Date (Press the (
Enter the current date in the format MM/DD/YY, where MM = the month
(01–12); DD=the day (01–31); and YY=the year. Press
NEXT (
Enter Time (Press the (
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
MM=minutes (00–59). Select Am or Pm by pressing any number button,
then press
Dealer Code
DCODE
Directly enter the Dealer Code, including leading zeros. Use the
through
J
to save.
••••••
Re-enter the Dealer Code to verify the previous code. Press
RE-ENT
Press NEXT (
NOTE: The Dealer Code can be two or more digits (up to 6 digits).
and then (d) press the
C
button to silence the keypad.
C
) button to set cursor.)
A
) button to proceed.
E
) button to set cursor.)
A
J
once again to save.
buttons. NOTE: Press the
9
) button to proceed.
E
button to exit the Dealer Program Mode. A System Trouble
X
GEM-P9600 Programming Instructions
Page 21
J
to save. Press
1
button for a zero. Press
0
J
to save.
!