Zone Descriptions - Gemini GEM-P9600 Programming Instructions Manual

!
Page 66
!
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press G 0
J
!
Press the button to save the code in memory.
!
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT (
GEM-RP2ASe2 Keypad
(Direct Entry)
ZONE DESCRIPTIONS (GEM-RP1CAE2 KEYPADS ONLY)
01-______________
________________
Enter an identifying description for each
zone. Buttons 1 and 2
cursor position; buttons 3
scroll numbers, letters, punctuation marks,
etc.
!
Position the cursor over the displayed
Zone Number (i.e., "01") using buttons
1 and 2 .
!
Change the Zone Number using buttons
and .
3 6
!
Position the cursor over the first
character of the description field.
Advancing the cursor between
characters, program a description of up
to two lines for the new zone using
buttons 3 and 6
J
!
Press the button to save. Advance to the next zone as in Steps 1 and 2 above and repeat this procedure until all zones have
been programmed.
X
GEM-P9600 Programming Instructions
button.
USER01
To Program User Codes
1. Enter 2-digit User Number
(01-96) directly using
number buttons (0-9).
2. Press the
3. Enter Code (1-6 digits)
123___
directly using number
buttons (0-9).
4. Press the
each code.
NOTE: Press
To Program Zone Descriptions
1. Set the Cursor Position using
buttons
2. Select characters for zone
set the
description using buttons
3
and 6
4. Press the
each descriptor.
NOTE: Press
.
button.
A
J
button to save
G 0 button to clear character at cursor.
To continue press E or F button.
Programming User Codes (GEM-RP2ASe2)
and .
1 2
and .
6
J
button to save
G 0 button to clear character at cursor.
To continue press E or F button.
Programming Zone Descriptions
WI777D 08/00
E ) button.
L
NAPCO Security Systems