Gemini GEM-P9600 Programming Instructions Manual page 68

!
Page 68
NEW COMPAT# 0000
keypad may not be removed for use on a system with a different compatibility number. Press the
continue or press the
C
EZM ADDRESS 01
designate the keypad as Group "01" at the "
group number "01" through "22". (Each EZM must have a unique assigned group number, starting with "01" and
proceeding consecutively.) Press the
Zone Response
ZONE RESPONSE 00
2. Add up the circled numbers.
3. At the keypad, enter the sum as a two-digit number "01" through "15" on the display, then press the
Example. Change Zones 2, 3 and 4 to 50mS response.
1. Circle numbers for Zones 2, 3 and 4: (2), (4) and (8).
2. Add up the circled numbers: 2 + 4 + 8 = 14.
3. Enter "14" at the keypad, then press the
Press the button to continue or press the
A
01 OUT OF SYSTEM
" "). Then replace Jumper JP5 across Pins 1–2 (top two).
X
GEM-P9600 Programming Instructions
Compatibility Number
The compatibility number is a 4-digit security code that, if programmed into
both the control panel and each GEM-RP1CAe2 keypad, dedicates the
keypad to only that panel. That is, (a) similar keypads not having the
correct compatibility number will not operate in the system and (b) a
button to exit.
EZM Address
The keypad's internal EZM (Expansion Zone Module) may be utilized to
provide four additional wired zones. Whether used alone or in conjunction
with optional GEM-EZM series modules or other keypad EZMs, it must be
assigned a unique address (or Group number, see Keypad Programming
Workbook) similar to its keypad address. If no other EZMs are to be used,
EZM ADDRESS 00
J
button. Press the
The normal loop response of each keypad expansion zone is 750mS,
however the response time of any zone can be reduced to 50mS as
follows.
1. Of the following, circle the number(s) in parentheses associated with the
zone(s) to be changed:
Zone 1=(1); Zone 2=(2); Zone 3=(4); Zone 4=(8)
J
button.
C
" display. In multiple-EZM systems, enter an assigned
button to continue or press the
A
button to exit the Keypad Configuration Mode (display will read
WI777D 08/00
button to
A
button to exit.
C
J
button.
L
NAPCO Security Systems