Central Station Receiver 1 Tel. Number; Central Station Receiver 1 Account Number; Central Station Receiver 1 Format - Gemini GEM-P9600 Programming Instructions Manual

!
Page 16
(Direct Entry)
Auto Download ID Number and PC Preset Callback Telephone Number: If the 1st digit of the Central Station Receiver 1
Telephone Number is an "F", then the 2nd and 3rd digits will be programmed as the Auto Download ID Number and digits 4 through
10 will be programmed as the PC Preset Callback Telephone Number.
ACC#
(____)
(Direct Entry)
entered in Direct Address Programming. See CS Reporting Options.
REC FMT
(0)
(Direct Entry)
DATA CS RECEIVER 1 FORMAT
ENTRY
blank(•) Ademco Slow, Silent Knight Slow
1 Sescoa, Vertex, DCI, Franklin
Fast
2 Radionics Fast
3 Silent Knight Fast
4 Radionics, DCI, Franklin Slow
5 Universal High Speed
8 Radionics BFSK
9 FBI 4/3/1
0 Radionics Modem 2
B SIA
C Ademco Point ID
D Ademco Express
E Pager
X
GEM-P9600 Programming Instructions
Central Station Receiver 1 Telephone Number
PHONE#
Press the
telephone number of up to 10 digits including prefix letters, if necessary, for
receiver 1. Use number buttons
the
G 0
______
5
Detection = "E". Pressing the
J
Press
NOTE: The GEM-RP2ASe2 keypad provides a maximum of 10 digits in this
______
mode. To program additional digits, go to the Direct Address Program Mode
and continue from Location 0537. Central Station Receiver 2 and 3
Telephone Numbers can only be entered in Direct Address Programming.
See CS Receiver Options.

Central Station Receiver 1 Account Number

Press the
four digits. Use number buttons
Press the
blank space (•). Press
respectively.
J
Press
NOTE: Central Station Receiver 2 and 3 Account Numbers can only be

Central Station Receiver 1 Format

Press the
central station's receiver format. Use number buttons
. NOTE: Press the
9
for a blank space (•). Press
B–E, respectively.
J
Press
NOTE: Modem IIe format is available only in Direct Address
Programming. Central Station Receiver 2 and 3 Formats can only be
entered in Direct Address Programming. See CS Receiver Options.
button to scroll screens. Using number buttons, enter
A
1
button for a zero and
for letters B–F, respectively. NOTE: Pre-Dial Delay = "D"; Dial-Tone
0
to save. Press NEXT (
E
button to scroll screens. Enter an account number of up to
A
1
button for a zero and press
G0
G 1
to save . Press NEXT (
E
button to scroll screens. From the table below, enter the
A
G 0
G 1
to save. Press NEXT (
E
WI777D 08/00
through for digits 1–9; press
9
through
G 1
button will produce a blank space (•).
) button to proceed.
through for digits 1–9. NOTE:
9
0
through for letters B–E,
G 4
) button to proceed.
1
button for a zero and press
through
G 4
) button to proceed.
L
NAPCO Security Systems
G
button for a
through
0
for letters