Key Fob Transmitters - Gemini GEM-P9600 Programming Instructions Manual

!
Page 20
KFOB01
AREA 0
000000
:0 0 0
(Direct Entry)
DATA AUX 1/AUX 2
ENTRY OPTIONS
0 None
1 Relay Group 1 Toggle
2 Relay Group 2 Toggle
3 Relay Group 3 Toggle
4 Relay Group 4 Toggle
5 Relay Group 5 Toggle
6 Relay Group 6 Toggle
example, On button = point 1; Off button = point 2; A1 = point 3; A2 = point 4. Up to 96 key fobs (using 1 button) or 48 key
fobs (using 2 buttons) or 28 key fobs (using all 4 buttons) or any combination up to a maximum of 96 controlled zones can
be assigned, providing multiple wireless panic buttons on a system, each reporting to the Central Station or a pager
and/or annunciating on a keypad the key fob zone number with description/location. To assign a key fob to a zone:
program the keyfob as you would a transmitter, entering the keyfob's ID code, check sum and point number at the
appropriate zone. The "Quick Method" is not allowed. The zone may be hardwired to a sensor as well as assigned to a
key fob (either one will activate the zone alarm output). NOTE: If assigning a key fob to a zone, the "ON/OFF" buttons on
the key fob will no longer arm/disarm the system. The key fob is converted to a "panic only" device.
ZONE DESCRIPTIONS: GEM-RP2ASe2 cannot be used to enter Zone Descriptions. To enter Zone Descriptions you
must use the GEM-RP1CAe2 Keypad or the Napco Quickloader Software.
X
GEM-P9600 Programming Instructions
Key Fob Transmitters (Press the (
Press the (
"Arm/Disarm" devices (refer to WI752). For each Key Fob Transmitter, enter:
!
the Key Fob Transmitter number (01–16).
!
area number to which transmitter is assigned (1 or 2); enter 0 to disable keyfob.
!
the 6-digit RF ID # printed on the transmitter (enter all numbers and/or
including leading "0"s, if any).
!
1-digit checksum number printed on the transmitter (enter all numbers
letters, including leading "0"s, if any).
!
Aux-1 Option (see key fob aux 1 & aux 2 options).
!
Aux-2 Option (see key fob aux 1 & aux 2 options).
Note: If the Key Fob is converted for Two Button "Emergency Use" (by
DATA AUX 1/AUX 2
ENTRY OPTIONS
7 Relay Group 7 Toggle
8 Relay Group 8 Toggle
9 Panic
A Auxiliary
B Instant
C Aux. Output Toggle
previous page: press the (
D Access on Aux.
Each of the 4 key fob buttons can be assigned to a zone. For
Output
A
) button to set cursor. Keyfobs can be programmed as
A
cutting an internal jumper), both top or bottom buttons must be
depressed to activate an alarms. In this case, the Aux-1 and Aux-2
cannot be programmed.
J
Press to save. Press NEXT (
Key Fob Zone Assignment (refer to display as shown on the
F
WI777D 08/00
) button to set cursor.)
NOTE: Key fobs 1-16
report openings
closings as Users 81-96.
) button to proceed.
E
) button to go backwards.)
L
NAPCO Security Systems
letters,
and/ or
and