Gemini GEM-P9600 Programming Instructions Manual page 69

WI777D 08/00
Configuring the GEM-RP2ASe2 and GEM-RP3DGTL Keypad
Up to 7 GEM-RP2ASe2 and/or GEM-RP3DGTL keypads may be connected to the panel (Keypads 1–7). Each must
be configured for a keypad address. In addition, the keypad may be configured to disable (a) touchpad backlight; (b)
LCD backlight; and (c) entry sounder. Keypads are configured by the proper selection of jumpers. Refer to the label
on the circuit board insulation paper for jumper locations and a summary of settings.
KEYPAD NUMBER
KEYPAD
NUMBER
1 2
1 OFF or OFF
ON*
2 OFF ON
3 ON ON
4 OFF OFF
5 ON OFF
6 OFF ON
7 ON ON
TOUCHPAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACKLIGHT
Cut Jumper B to disable LCD backlighting.
DISABLE SOUNDER
Cut Jumper C to disable the sounder. (Do not disable in UL applications.)
L
NAPCO Security Systems
KEYPAD ADDRESS
If more than one keypad is installed:
!
3
PARK
be numbered alike).
OFF
!
not permitted).
OFF
!
STORE SPARE
OFF
programming, it is recommended that a GEM-RP1CAe2 be selected as
JUMPER AT THIS
OFF POSITION
Keypad #1.)
Assign the keypad address number by selecting Jumpers J1–3 in
ON
accordance with the table at left.
ON
*Note: (1) Keypads are factory supplied with no jumpers installed
ON
and a as such are automatically configured as Keypad No. 1. (2)
Only one keypad in the system may be configured as Keypad No. 1,
otherwise none will function.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
Each must be assigned a unique address (that is, no two keypads may
Keypads must be addressed consecutively (that is, missing numbers are
Only Keypad No. 1 may be used for programming. (However, for ease of
NAPCO Security Systems, Inc.
X
GEM-P9600 Programming Instructions
!
Page 69