Gem-Rp2Ase2 Keypad; Number Of Zones & Keypads Per Area - Gemini GEM-P9600 Programming Instructions Manual

!
Page 14
B. GEM-RP2ASe2 Keypad
Enter the Master Security Code (printed on microprocessor can) for a new panel or enter your custom
GEMINI
SYSTEM ARMED
Dealer Program Code if programmed. Press
A1#Z08 ENT A1
01/01/97 12:00AM
NEXT/YES
A 1 2 3 E
D PROG
" is displayed. NOTE: If you pass "
PRIOR/NO
B 4 5 6 F
AREA
C 7 8 9 0 G
button. Press YES (
COMPUTERIZED SECURITY SYSTEM
R
multiple segments. Press the
(Direct Entry)
(Direct Entry)
(Direct Entry)
(Direct Entry)
X
GEM-P9600 Programming Instructions
) to enter the Dealer Program Mode. This keypad displays messages in
E
button to scroll through each segment.
A
Total Number of Zones in Area 1 & Area 2 (Appears for New Panel Only)
Directly enter the total number of zones to be programmed for Area 1 and
ENT A1
Area 2, respectively. Valid entries are from 01 to 96. Directly enter the total
number of zones, including leading zeros. Use number buttons
through
based on groups of 4 zones each (after the first 8 zones), and will
#ZN08
automatically round up to the next group of 4. For example, if you enter 18,
it will automatically convert this to 20 zones. Press
( ) button to proceed.
E
ENT A2
Note: The GEM-P9600 is limited to a combined maximum of 96 zones and
15 keypads. All 96 zones and 15 keypads may be programmed in the EZ
Program Mode. For more options, see Zone and Keypad Options in Direct
Address Programming.
#ZN00
Fire Zones (Appears for New Panel Only)
Enter the zone number of any Fire Zones (both 2-wire, 4-wire or wireless).
ENT FR
Valid entries are from 01 to 96. Directly enter each zone number, including
leading zeros, and press
zone(s). Press NEXT (
NOTE: If you are programming a 2 Area system, enter the zone number of
ZN#00
zones required for Areas 1 & 2. All fire zones are common to areas 1 and 2.
The Direct Address Program Mode can then be used to customize them as
needed. See Zone Options.
2-Wire Fire Zones (Appears for New Panel Only)
Enter the zone number of any Fire Zones (from previous question) which
ENT2WF
are to be used with 2-wire smoke detectors. The only valid entries are 01-08.
Directly enter each zone number, including leading zeros. Press
and then repeat for any additional zone(s). NOTE: Only zones which have
been designated as Fire Zones can be programmed as 2 Wire Fire zones.
ZN# 00
Press NEXT (
position for 2-wire fire zones 7 and 8 (refer to Installation Instructions).
followed by NO (
A
TURNON/PROG
", you can scroll back by pressing the
. NOTE: Press the
9
J
to save, and then repeat for any additional
) button to proceed.
E
) button to proceed. NOTE: JP7 must be set to "2-WF"
E
) repeatedly until "
F
button for a zero. The system is
0
J
to save. Press NEXT
L
NAPCO Security Systems
WI777D 08/00
TURNON/
B
1
J
to save,