System Armed; Alarm, Neutral Time Between Alarms And Alarm Cycles; System Disarming; Emergency Disarming By Electronic Key - Gemini 933 Series Installation And Use Manual

2.5 - SYSTEM ARMED

After the arming delay, the system is fully armed and ready to detect any alarm condition. When the
system is fully armed, the LED starts flashing.

2.6 - ALARM, NEUTRAL TIME BETWEEN ALARMS AND ALARM CYCLES

An alarm condition is indicated by optical/acoustic signals.
After the alarm is triggered, but before another alarm cycle starts,
for about 5".
An alarm event generates a maximum of ten 30" alarm cycles for each input and for each arming cycle

2.7 - SYSTEM DISARMING

Press the unlock button on the vehicle original remote control.
Disarming is confirmed by 2 siren chirps
indicators.
An alarm condition is signalled by 5 acoustic signals (if feature has been configured) and 5 flashes of
the turn indicators.
Paragraph 2.9 below lists the various alarm causes and relative LED

2.8 - EMERGENCY DISARMING BY ELECTRONIC KEY

This disarming mode is used for "EMERGENCY DISARMING" and "TOTAL DISARMING".
Touching the electronic key to its receptable disarms and switches off the system which does not
rearm when the remote control is used.
To restore normal operation, touch the electronic key to its receptacle.
A quick chirp and a flash of the status LED will confirm that the system is back to normal

2.9 - ALARM MEMORY

Five flashes of the turn indicators and 5 siren
disarming the system, indicate that an alarm event has occured while the system was armed. The LED
memory allows to determine the cause that generated the last alarm.
Turn ignition key "ON" ; the vehicle status LED will blink according to the last alarm detected.
The flash sequence is repeated 3 times; to interrupt, turn ignition key "OFF".
The table below lists the various alarm causes and relative LED signals.
LED FLASHES
LED OFF (2 seconds) LED ON (1 second)
PAGE 04 - USER MANUAL
the system goes into "neutral time"
(if feature has been configured) and 2 flashes of the turn
signals.
mode.
chirps ( if feature has been configured
ALARM CAUSES
Ignition attempt (+15/54)
Door opening
Bonnet opening
Boot opening
Volumetric or external sensor
Wire tampering
This product is guaranteed to be free from manufacturing defects for a period of 24 months from the
installation date shown on this warranty, in compliance with the Directive 1999/44/CE.
Please fill-in entirely the guarantee certificate included in this booklet and do NOT REMOVE the
guarantee label from the device.
The warranty will become void if labels are missing or torn, if the installation certificate is not fully
compiled or if the enclosed sale document is missing.
The guarantee is valid exclusively at authorized Gemini Technologies S.p.A. Service Centers.
.
The manufacturer declines any responsibility for eventual malfunctions of the device or any damage
to the vehicle electrical system due to improper installation, use or tampering.
This alarm system is solely intended to be a theft-deterrent device.
4.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.
), t riggered when
ALARM
CYCLES
10
10
1 0
10
10
10
3.0 - WARRANTY CONDITIONS
(WEEE) DIRECTIVE
USER MANUAL - PAGE 05