System Operation - Basic Configuration; Arming; Topcase/Seat Open Warning; Arming Delay - Gemini 953N User's And Installer's Manual

3.0 - SYSTEM OPERATION - BASIC CONFIGURATION

3.1 - ARMING

To arm the system, press remote control button "1". Arming is confirmed by 2
Beeps and 1 flash of the turn indicators and the status LED turns ON steady.

3.2 - TOPCASE/SEAT OPEN WARNING

If, when arming the system, the topcase or the seat are open or incorrectly
closed, 1 Bop will sound after the arming confirmation tones.
The system will arm but an alarm condition will be triggered after the arming
delay.

3.3 - ARMING DELAY

After the arming confirmation tones, the LED turns ON steady for approx. 20
sec. to signal the arming delay countdown.
The engine immobilizer and optional module outputs are enabled during the
arming delay.

3.4 - SIREN EXCLUSION

During the first 4 sec. of the arming delay, the siren can be excluded by
pressing remote control button "2".
Siren exclusion is confirmed by a quick flash of the turn indicators.
CAUTION
If the siren is excluded, only the turn indicators will flash during an alarm
event. Siren exclusion is bound to a single arming cycle.
The engine immobilizer feature remains enabled.

3.5 - TILT SENSOR TEMPORARY EXCLUSION

When the system is disarmed, turn ignition key in "ON". As the LED lights up,
approx. 1 sec., press remote control button "2". The status LED will blink once to
confirm that the sensor has been excluded.
The sensor cannot be excluded if the passive arming feature is enabled.
CAUTION
Exclusion is bound to a single arming cycle.
PAGE 5
3.6 - ARMED CONDITION
After the 20 sec. arming delay, the system is fully armed and ready to detect
any irregularity. The LED will start flashing to confirm the armed condition.

3.7 - ALARM EVENTS

If an alarm event is detected during the armed state, the siren will sound, the
LED will turn ON steady and the turn indicators will flash repeatedly for approx.
30 sec.
The following irregularities will trigger an alarm if the relative sensors have
been enabled:
!
Cable cut tamper detection.
!
Ignition attempt.
!
Tilt detection.
!
Seat/topcase tampering (if protected by a contact switch .
!
Panic alarm (by pressing remote control button "2").
After the alarm cycle, the system returns in armed mode.
To interrupt the siren and the flashing of the turn indicators during an alarm
event, without disarming the system, press remote control button "2".

3.8 - LIMITATION OF AUDIBLE ALARMS

Alarm events caused by unauthorized motion, seat/topcase tampering or
ignition attempts will trigger the siren for 7 consecutive cycles.
The siren will then be automatically excluded for the following reasons:
!
To comply with the regulations in force aimed at limiting noise pollution.
!
To save power and maximize vehicle battery life.
!
If, after 7 cycles, no one checks the vehicle, it is useless to have it sound
again.

3.9 - NEUTRAL TIME BETWEEN ALARM EVENTS

Once the alarm cycle is over, further alarm events will be ignored for 5 sec.; the
LED will be ON steady.
During neutral time, the system can be disarmed via PIN code (see par. 7.0 and 8.0).
)
PAGE 6