Shock Sensor Exclusion; Armed Condition; Alarm; Limitation Of Acoustic Signals - Gemini 953 Installation And Use Manual

4.5 - SHOCK SENSOR EXCLUSION

The alarm built-in sensor to detect tilt, motion or a sudden shock can be
excluded during the first 4" of the arming delay time by inserting the electronic
key into its receptacle (after the alarm system is armed). The status LED will
blink once to confirm the sensor has been excluded.
NB: Sensor exclusion is bound to a single arming cycle.

4.6 - ARMED CONDITION

After the 20" arming delay, the alarm system is fully armed and ready to detect
any irregularity. The LED will start blinking to confirm the armed condition.

4.7 - ALARM

If an alarm condition is detected during the armed state, the siren will sound, the
LED will turn ON steady and the turn indicators will flash repeatedly for approx. 30
seconds.
The following irregularities will trigger an alarm if the relative sensors are
activated :
!
Cable cut tamper detection;
!
Ignition attempt ;
!
Motion detection (ex. lifting, towing, forcing the steering lock);
!
Seat/topcase tampering (if protected by a contact switch
!
Panic siren (by pressing remote control button 2).
After the alarm condition ceases, the system returns in armed mode
To interrupt the siren and the flashing indicators during an alarm condition,
without disarming the alarm , press remote control button 2.

4.8 - LIMITATION OF ACOUSTIC SIGNALS

Alarm events caused by unauthorized movement, seat/topcase tampering or
ignition attempts will trigger the siren for 7 consecutive cycles.
The siren will then be automatically excluded for the following reasons:
!
To comply with the regulations in force aimed at limiting noise pollution;
!
To save power and maximize vehicle battery life;
!
If, after 7 cycles, no one checks the vehicle, it is useless to have it sound again.
4.9 -

NEUTRAL TIME BETWEEN ALARM EVENTS

When the alarm cycle is over, any further alarm event will be ignored for 5
seconds; the LED will be ON steady.
During neutral time, the system can be disarmed by PIN Code (see chapters 8
and 9) .
Page 5

4.10 - SYSTEM DISARMING WITHOUT ALARM MEMORY

To disarm the alarm system, press remote control button 1 or insert the
electronic key in its receptacle. The LED will turn OFF and disarming will be
confirmed by 3 beeps and 3 flashes of the turn indicators.

4.11 - SYSTEM DISARMING WITH ALARM MEMORY

If an alarm event has occurred while you were away from your vehicle, it will
be signalled by 2 flashes of the turn indicators and 2 low-tone beeps
The last cause of alarm can be identified as follows by observing the status LED:
Shock sensor alarm:
Ignition attempt alarm:
Topcase/seat alarm:
);
.
Cable cut alarm:
The alarm system is factory preset with some features enabled and others
disabled. Th
Feature
Acoustic signals
Panic siren
Shock sensor
Passive arming
Anti-hijack
Pre-alarm
Self-rearming
5.0 -

PROGRAMMABLE FEATURES

e shock sensor is preset at minimum sensitivity.
Factory settings
Status
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
.
Page 6