Figure 82 - Neighbor Table - Cal Amp Dataradio HiPR-900 User Manual

Item
Unit ID
Unit Configuration
Route
Status
Del
Poll
Poll All
Clear List
Refresh List
001-5099-000

Figure 82 - Neighbor Table

Displays a neighboring unit's RF MAC address and name.
RF IP Address: displays a neighboring unit's RF IP address and net-
mask.
Ethernet IP Address: displays a neighboring unit's Ethernet IP address
and netmask.
#: Indicates whether the route is primary [pri] or backup [bkp]
The neighbor discovery algorithm keeps information about two best
paths to any neighboring unit. The primary path is used (by default)
when building the internal routes. Use Toggle function to manually
switch to the backup path.
Next Hop: Indicates the ID of the unit that's next on the path to the
neighboring unit. (If the neighboring unit is only 1-hop away the field
indicates the ID of the neighboring unit itself)
Hop Count: Indicates the number of RF hops from the unit to the neigh-
bor. 1-hop neighbor is a neighbor that a unit can talk directly to: both
units are in the same RF coverage area. 2 and more hop neighbors are
neighbors that cannot be reached directly.
Status: Indicates if the route is active or inactive.
Toggle: Switches between primary and backup route. The toggle
switching can take up to 1500 ms to take effect and if the backup path
is the desired path, the path should be locked (see section 6.7.7)
Displays the unit's status:
Unit's Operating mode: Master, Repeater or Remote
Relay Point (RP) if enabled
NAT if enabled
Access Point (AP) if enabled
Proxy if TCP is enabled
Static if neighbor entry was defined by the user, Dynamic if the entry
was acquired by the neighbor discovery module
Deletes the neighboring unit from the Neighbor Table. If the unit still
exists in the RF network, the neighbor discovery module will find it. To
see it appear in the Neighbor Table the user may press Refresh List
button, allowing sufficient time for the neighbor discovery module to
locate the unit.
Polls the unit. Used to test if a unit is reachable.
Polls all units in the Neighbor Table.
Clears the Neighbor Table. Deletes all entries.
Refreshes the Neighbor Table. Note that this page does not refresh
automatically
75
Description
HiPR-900 User Manual