Ip Network Settings In Router Mode (With Host); Ip Network Settings In Router Mode ( With Host ) - Cal Amp Dataradio HiPR-900 User Manual

6.3.3 IP Network Settings in Router Mode (with Host)

(Exclusive to the full-featured HiPR-900 version)
Referring to Figure 16, set one of the HiPR-900 as a Master. Set the Router mode on the Master and Re-
mote. Set the Eth1 IP addresses and IP netmask of both Master and Remote.
Keep the RF IP setting as is if not using the 10.0.0.0 IP network on your Intranet.
Enable the Dynamic Registration on both Master and Remote.
Add routes in the Host (route add...) and add Default Gateway to RTU
HiPR-900 Master
Dynamic Registration
Eth1 IP: 172.30.1.2
MASK: 255.255.255.0
route add 172.30.2.0 mask 255.255.255.0 172.30.1.2
route add 10.0.0.0 mask 255.0.0.0 172.30.1.2
In the illustration, Host and RTU are part of different IP subnet.
001-5099-000
DHCP Server
RF IP: 10.x.y.z
MASK: 255.0.0.0
Host
IP: 172.30.1.1
MASK: 255.255.255.0
Figure 16 - IP Network Settings in Router Mode (with Host)
HiPR-900 Remote
Dynamic Registration
RF IP: 10.a.b.c
MASK: 255.0.0.0
RF Network
20
DHCP Server
Eth1 IP: 172.30.2.1
MASK: 255.255.255.0
RTU
IP: 172.30.2.2
MASK: 255.255.255.0
Default Gateway: 172.30.2.1
HiPR-900 User Manual