Setup (Basic); Setup (General); Setup - Cal Amp Dataradio HiPR-900 User Manual

Item(cont'd)
Sync Status
Temperature
Power Source
H/W Status
Homologation
Clear H/W Status
Flash Power LED

6.7.2 Setup (Basic)

6.7.2.1

Setup (General)

Figure 30 - Setup (Basic) General -full-featured HiPR-900 (left), HiPR-900S (right)
001-5099-000
For remote and repeater units - Displays unit sync status in relation to Master
Displays unit's internal temperature
Indicates voltage input used: "Power over Ethernet "or "DC input"
Summary report of hardware error checking at Power ON self-test. Works in conjunc-
tion with the front panel Power LED (flashing red). Displayed sentence always starts
with "HW failure...". Unit will reset (as if power was cycled) 5 minutes after a self-test
error is detected.
Summary report of driver error detection. Works in conjunction with the front panel
Power LED (flashing green). Unit will not reset.
For both types of reports, have the displayed H/W Status message (or combination of
messages) handy if contacting Dataradio support. Also required if returning unit for
service under RMA.
Factory-set. Shows the territory the unit has been configured for operation and ap-
proved by the appropriate governmental authority.
Informational display: North America, New Zealand, or Australia
Button allowing user to acknowledge and clear errors.
Errors remain stored, even after cycling power, to aid in troubleshooting intermittent
faults. Press the "Clear H/W Status" button to return web page displays and Power LED
function to normal operation.
Button allowing user to assure that he/she is setting up the correct unit.
Press "Flash Power LED" button to see the power LED flash on this unit for 30
seconds.
Description
29 HiPR-900 User Manual