Ip Optimization & Tuning; Ip Routing (Exclusive To The Full-Featured Hipr90 Version) - Cal Amp Dataradio HiPR-900 User Manual

6.7.3.5 IP Optimization & Tuning
Figure 63 - Advanced IP Configuration – IP Optimization & Tuning (Router Mode)
Item
RF ACK
OIP Retries
Note: No optimizations are available in Bridge Mode. Figure 63 shows Router mode screen.
6.7.3.6

IP Routing (exclusive to the full-featured HiPR90 version)

Item
IP Routing Table
Destination
Netmask
Gateway
Type
Add/Delete
001-5099-000
Disabled (Default), Enabled
Number of OIP retries (for non TCP traffic like ICMP). Default = 1
Figure 64 - Advanced IP Configuration – IP Routing
Displays the table of IP routes that are active in the HiPR-900.
IP address of the route
Netmask of the route
Gateway of the route (next hop)
Static routes: User-defined routes.
Dynamic routes: Routes learnt by the HiPR unit with RIPv2 protocol.
(RIPV2 must be enabled in Setup (Advanced) → IP Services)
Direct routes describe addresses that are directly reachable (1 hop
away).
Indirect routes describe addresses that cannot be reached directly (i.e.
addresses that are more than one hop away).
Allow the user to add or remove routes manually to/from the table.
Warning: Manipulate this table with caution!
61
Description
Description
HiPR-900 User Manual