Cal Amp Dataradio HiPR-900 User Manual page 37

When making an entry into a dialog box, click on Apply when satisfied to temporarily apply the value(s)
entered to the relevant parameter(s). If not satisfied, click on Cancel button to restore to the value(s)
present before a change was made.
Note: Cancel command only affects the dialog boxes or radio buttons in the opened window
If needed, go to other Submenu(s) and make more entries. Click Apply before leaving each window.
When finished, click the Save Config button to make all changed entries permanent.
Notes:
"Apply" writes to RAM, thus failure to use the "Apply" command button before leaving a web
page will result in the loss of temporarily entered selections, addresses, and values.
"Save Config" writes in flash, thus failure to use the "Save Config" command button will result
in the loss of temporarily entered parameters. A "Reset" is required to make flash changes take
effect.
Use the Save Config command button before doing a Reset Unit otherwise temporarily entered parame-
ters would be lost.
Click on Save Config button:
•
If there are changes to be saved, saving occurs automatically.
•
If there are no changes to be saved, a sub-window prompts user to confirm saving.
Click on "Reset Unit" button:
•
If there are changes to be saved, a sub-window prompts user to confirm resetting.
•
If there are no changes to be saved, resetting occurs automatically.
A "Station Reset" 20-second timer counts down while the status reports: "Working..."When done, the
status reports: "Ready"
001-5099-000
Figure 21 - Web User Interface – Welcome Screen
Figure 22 - Attention sub-window
24 HiPR-900 User Manual