Login Screen; Initial Installation Login; Web Interface; Apply, Cancel, Save Config, And Reset Unit - Cal Amp Dataradio HiPR-900 User Manual

6.4

Login Screen

On your Internet browser address line, type the factory-default IP address given to all HiPR-900 radio
modem units: 192.168.204.1. Press Enter. The Enter Network Password screen opens.
Figure 20 - Enter Network Password screen (appearance may vary with browser used)

6.4.1 Initial Installation Login

For an initial installation, enter a User Name of 1 to 15 characters and the default Password
ADMINISTRATOR (upper case letters). Click OK. The web interface "Welcome" screen (Figure 21)
opens together with the "Attention" sub-window.
Dataradio recommends immediately running the Setup Wizard. Once completed, proceed to change the
HiPR-900 radio modem login password as detailed in section 6.7.4.1 below. Do not lose the new pass-
word! Should the password be lost, you will need to contact Dataradio support as detailed in section 1.3
earlier.
For subsequent access to the HiPR-900 unit, use the User Name and Password that you will have confi-
gured.
Note:
The User Name entry is currently not an access-limiting factor. It only serves to identify the per-
son gaining access. User Name may be required by future versions.
6.5

Web Interface

Important note: Record all original HiPR-900 factory settings for possible future use.
Note: It is always possible to restore factory settings through the web interface (see section 6.7.6.2).
The HiPR-900 web user interface is used to configure and view your network settings. To navigate, use
the nine top-level menus on the left, five of which expand to offer submenus.
Note: Screen captures used throughout this document may vary slightly from actual screens.

6.5.1 Apply, Cancel, Save Config, and Reset Unit

Several submenus have "Apply" and "Cancel" buttons.
The navigation area has "Save Config" and Reset Unit" buttons.
001-5099-000
192.168.204.1
23 HiPR-900 User Manual