Ip Addressing Modes - Cal Amp Dataradio HiPR-900 User Manual

6.7.3.4

IP addressing modes

Item
Directed Broadcast
Broadcast
Limited Enable
Multicast
Outbound unit address
Multicast Address List
Multicast
Add / Delete Address
Address List
001-5099-000
Figure 52 - Advanced IP Configuration – IP adressing modes
Disabled, Enabled (Default) – Controls forwarding of
Directed Broadcast packets
Disabled (Default), Enabled – Controls forwarding of
Limited broadcast packets
Disabled (Default), Enabled – Controls forwarding of
Multicast packets (based on the "Multicast Address
List")
Multicast can be used when "one-to-many" communi-
cation is required.
Multicast address associated to remote unit
To add an address to the Multicast List:
Select the "Add" radio button and type in the dialog
box the new address to be added to the read-only
"Address List". Note that only the valid multicast ad-
dresses will be accepted and displayed.
To delete an address from the Multicast List:
Select the "Delete" radio button and type in the dialog
box the address to be deleted from the "Address List".
Read-only listing. Window expands downward as
needed to show all addresses in the list.
When an IP packet is received on the Ethernet side of
the unit and the destination IP address matches one of
the multicast IP addresses in this list, it is forwarded
over the RF interface.
Remote units will send it over their Ethernet interface.
Description
52 HiPR-900 User Manual