Table of Contents
Advertisement
3.1
LEDS
HiPR-900 has five dual-color LED indicators. Their functions are shown in Table 3.
LED
ACT
LINK
Tx / Rx
SYNC
Amber (at boot-up)
PWR
* Unit will reset (similar to power input recycling) 5 minutes after self-test hardware error is
detected (only done at Power ON).
Note:
Power LED steadily lit red or flashing red will require factory repair. Power LED flashing green will
require factory repair only if the unit is unable to transport traffic. Refer to section 1.4.1, RMA
REQUEST for mandatory factory repair procedure.
3.2
User Connector Pin-outs
3.2.1 Ethernet LAN Port
Contact
1
2
3
4
5
6
7
8
SHELL
(1) The name shows the default function. Given the auto-MDIX capability of the Ethernet transceiver,
TX and RX function could be swapped.
Note:
The HiPR-900 unit accepts PoE over the cable spare conductors and/or Data baring conductors as
follows:
Spare conductors: pins [4,5] as (+) or (-), pins [7,8] as the other polarity
Data baring conductors: in common mode, pins [1,2] as (+) or (-), pins [3,6] as the other polarity
001-5099-000
Table 3 - HiPR-900 LEDs indications
Color
Green
Data transmission or reception activity – Off if no activity
Green
Amber
Green
Amber
Red
Green
Red
Green
Amber
Red
Flashing red = Power ON Self-test hardware error detection*
Table 4 - Pin-out for IEEE-802.3af RJ-45 receptacle contacts
Definition
Connection OK, no collision
Connection OK, with collision
Data reception activity
Data transmission activity
Receive CRC error or incomplete packet
Remote/Repeater: In sync with Master
Master: Normal
Remote/Repeater: Loss of Master sync
Steady red = Master failure
Steady green = Normal
Flashing green = Driver error
Normal (approx 5 secs)
Application failure
Steady red = Hardware failure
10/100Base-T signal
(1)
TXP
(1)
TXN
(1)
RXP
SPARE +
SPARE +
(1)
RXN
SPARE -
SPARE -
Shield
9
HiPR-900 User Manual
Advertisement
Table of Contents
Troubleshooting
