Operation & Configuration; Lan Setup; Default Ip Settings; Ethernet Interface - Cal Amp Dataradio HiPR-900 User Manual

6. Operation & Configuration
Instructions and examples given in this manual are based on HiPR-900 operating software version at the
time of writing this document and may not apply to earlier or later software versions. Screen captures
used throughout this document may vary from actual screens.
6.1

LAN Setup

Check that DC power is applied to the HiPR-900 radio modem (PoE or PWR input). On a PC running
MS-Windows with an existing LAN connection, connect to the RJ-45 input of the HiPR-900. Set-up PC
as follows:
1. Click Start
2. Click on the relevant Local Area Connection
3. On the Local Area Connection Status screen, click Properties
4. On the Local Area Connection Properties screen, scroll the List Box until "Internet Protocol
(TCP/IP)" is highlighted, click Properties
5. On the Internet Protocol (TCP/IP) Properties screen, follow either method below:
A) Select "Obtain an IP address automatically"
B) Select "Use the following IP address"
255.255.255.0 in the Subnet mask
6. Click the OK button
Note: Certain Operating Systems require rebooting to complete the connection process.
6.2

Default IP Settings

•
Default Operating mode is Remote
•
Default IP Forwarding mode is Bridge
•
Time Division Duplex (TDD) RF protocol is enabled by default

6.2.1 Ethernet Interface

•
MAC:
•
IP ADDR:
•
NETMASK:
•
Default Gateway:
•
DHCP Server

6.2.2 RF Interface

•
MAC:
•
IP ADDR:
•
NETMASK:
•
TCP Proxy
001-5099-000
Control Panel Network Connections
00:0A:99:XX:YY:ZZ
192.168.204.1
255.255.255.0
0.0.0.0
Enabled
00:XX:YY:ZZ
10.XX.YY.ZZ
255.0.0.0
Disabled
Enter 192.168.204.254 in the IP address field
Leave the Default gateway blank.
18 HiPR-900 User Manual