Table of Contents
Advertisement
6.7.6.3
Package Control
Package Control is used for verifying the integrity of the field upgrade of the HiPR-900 radiomodem
firmware.
Click on Maintenance/Package Control and wait a few seconds for the results to display.
Snapshot in Figure 76 shows a "PASS" result indication. If an upgrade problem arises and persists, click
the "Package Control" once more and have the resulting indications handy if contacting Dataradio System
engineering.
6.7.6.4
Radio Tests
To guard against an inadvertent or accidental mishap, Dataradio strongly recommends saving the parame-
ters to the unit BEFORE running this test. Use the "Save Config" button at the bottom of the navigation
menu. This test is especially useful for testing the power output with a wattmeter.
Item
Start Test
Stop Test
001-5099-000
Figure 76 - Package Control
Figure 77 - RF Tests
Test frequency is 915.000 MHz, carrier only (no modulation)
RF Power will be as configured in:
"Setup (Basic)"
"RF Setup" (20 to 30 dBm)
HiPR-900 unit resets after 20 seconds if the Stop Test button is not
pressed.
71
Description
HiPR-900 User Manual
Advertisement
Table of Contents
Troubleshooting
