Front Panel(S) Installation; Front Panel(S) Installation With Rear Hard Top Removed; Rear Hard Top Removal - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 102 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 2B8E1DB2
/chry_pdm/chrysler/owners/wra/og
Wrap the upper strap around the rear head
restraints and loop the strap through the
buckle. Pull on the strap to tighten the Freedom
bag securely against the rear seat.
art=035707996.tif

Front Panel(s) Installation

NOTE:
Set the panels on the windshield frame so
that there is no overhang. Also, make sure
that the panels are sitting flush with the
body.
1. Install the right panel first, then the left panel.
2. Reinstall the panel(s) using the same steps
for removal in reverse order.
100
NO TRANS
art=035707391.tif
Front Panel(s) Installation with Rear
Hard Top Removed
1. Turn the left and right panels over and move
the spacer block (located on the rear of the
panel) upward 90 degrees.
NO TRANS
NOTE:
The front panel(s) must be positioned prop-
erly to ensure sealing. Set the panels on the
windshield frame so that there is no over-
hang. Also, make sure that the panels are
sitting flush with the body.
2. Install the right panel first, then the left panel.
3. Reinstall the panel(s) using the same steps
for removal in reverse order.

Rear Hard Top Removal

1. Remove both front panels. Refer to "Front
Panel(s) Removal" in this section.
2. Open both doors.
3. Remove the two Torx head screws that
secure the hard top at the B-pillar (near the top
of the door) using a #40 Torx
(Four–Door Only).
4. Remove the six Torx head screws that
secure the hard top to the vehicle (along the
interior bodyside) using a #40 Torx
driver.
5. Open the swing gate all the way to ensure
clearance of the rear window glass. Lift the rear
window glass.
head driver
head