Windshield Wipers And Washers; Windshield Wiper Operation - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 89 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 3E5F2F90
/chry_pdm/chrysler/owners/wra/og
ing switch is located on the lower switch bank
(below the climate controls).
art=031402646.tif NO TRANS
To operate: With the low beams on,
push the upper side or lower side
of the headlight leveling switch un-
til the appropriate number, which
corresponds to the load listed on
the following chart, illuminates on
the switch.
NOTE:
Headlight Leveling will not activate when the
parking lights or high beam headlights are
on.
0 Driver only, or driver
and front passenger.
1 All seating positions
occupied.
2 All seating positions
occupied, plus an
evenly distributed
load in the luggage
compartment. The
total weight of pas-
sengers and load
does not exceed the
maximum load ca-
pacity of the vehicle.
3 Driver, plus an evenly
distributed load in the
luggage compart-
ment. The total
weight of the driver
and load does not
exceed the maximum
load capacity of the
vehicle.
Calculations based on a passenger weight of
165 lbs (75 kg).
WINDSHIELD WIPERS AND
WASHERS
The windshield wiper/washer control lever is
located on the right side of the steering column.
The front wipers are operated by rotating a
switch, located at the end of the lever. For
information on using the rear window wiper/
washer, refer to "Rear Window Features" in
"Understanding the Features of Your Vehicle".
art=036407502.tif NO TRANS
Windshield Wiper/Washer Lever

Windshield Wiper Operation

Rotate the end of the lever upward to the
second detent past the intermittent settings for
low-speed wiper operation.
Rotate the end of the lever upward to the third
detent past the intermittent settings for high-
speed wiper operation.
87