Jeep 2010 Wrangler Owner's Manual page 172

JOBNAME: CHRY OM INTL (Conten PAGE: 172 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 461D2E0B
/chry_pdm/chrysler/owners/wra/og
The operator can override the AUTO mode
setting to change airflow distribution by rotating
the Mode Control knob (on the right) to one of
the following positions.
• Panel
art=045600242.tif
Air is directed through the outlets in the
instrument panel. These outlets can be
adjusted to direct airflow.
NOTE:
The center instrument panel outlets can be
aimed so that they are directed toward the
rear seat passengers for maximum airflow
to the rear.
• Bi-Level
art=045600241.tif
Air is directed through the panel and
floor outlets.
NOTE:
For all settings except full cold or full hot,
there is a difference in temperature between
the upper and lower outlets. The warmer air
flows to the floor outlets. This feature gives
improved comfort during sunny but cool
conditions.
170
art=045600240.tif
NO TRANS art=045600239.tif
art=045600238.tif
NO TRANS
• Floor
NO TRANS
Air is directed through the floor outlets
with a small amount flowing through the
defrost and side window demist outlets.
• Mix
NO TRANS
Air is directed through the floor, defrost,
and side window demist outlets. This
setting works best in cold or snowy
conditions that require extra heat to the
windshield. This setting is good for maintaining
comfort while reducing moisture on the wind-
shield.
• Defrost
NO TRANS
Air is directed through the windshield
and side window demist outlets. Use
this mode with maximum blower and
temperature settings for best windshield and
side window defrosting.
• Air Conditioner Control
art=045607779.tif NO TRANS
Press this button to turn
on the air conditioning
during manual opera-
tion only. When the air
conditioning is turned
on, cool dehumidified
air will flow through the
outlets selected with the
Mode control dial. Press
this button a second
time to turn OFF the air conditioning. An LED in
the button illuminates when manual compres-
sor operation is selected.
• Recirculation Control
art=045600600.tif NO TRANS
The system will automatically con-
trol recirculation. However, press-
ing the Recirculation Control but-
ton will temporarily put the system
in recirculation mode (ten min-
utes). This can be used when out-
side conditions such as smoke, odors, dust, or
high humidity are present. Activating recircula-
tion will cause the LED in the control button to