Intermittent Wiper System; Windshield Washers; Mist Feature - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 90 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 396FBF8F
/chry_pdm/chrysler/owners/wra/og
art=031507503.tif
CAUTION!
In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine. If
the wiper switch is left on and the wipers
freeze to the windshield, damage to the wiper
motor may occur when the vehicle is re-
started.

Intermittent Wiper System

Use the intermittent wiper when weather con-
ditions make a single wiping cycle, with a
variable pause between cycles, desirable. Ro-
88
NO TRANS
Front Wiper Control
tate the end of the lever to the first detent
position for one of five intermittent settings. The
delay cycle can be set anywhere between 1 to
18 seconds.
art=031507503.tif NO TRANS
Front Wiper Control
NOTE:
The wiper delay times depend on vehicle
speed. If the vehicle is moving less than
10 mph (16 km/h), delay times will be
doubled.

Windshield Washers

To use the washer, pull the lever toward you and
hold while spray is desired. If the lever is pulled
while in the delay range, the wiper will start and
continue to operate for two or three wipe cycles
after the lever is released, and then resume the
intermittent interval previously selected.
If the lever is pulled while in the off position, the
wipers will operate for two or three wipe cycles
and then turn off.
WARNING!
Sudden loss of visibility through the wind-
shield could lead to a collision. You might not
see other vehicles or other obstacles. To avoid
sudden icing of the windshield during freezing
weather, warm the windshield with defroster
before and during windshield washer use.

Mist Feature

Push down on the wiper lever to activate a
single wipe to clear off road mist or spray from
a passing vehicle. As long as the lever is held
down, the wipers will continue to operate.