To Unlock The Doors And Swing Gate; To Lock The Doors And Swing Gate; To Turn Off "Flash Lights With Lock - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 19 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 35BC5368
/chry_pdm/chrysler/owners/wra/og
Entry (RKE) transmitter. The transmitter does
not need to be pointed at the vehicle to activate
the system.
art=020200447.tif NO TRANS
Remote Keyless Entry (RKE) Transmitter
NOTE:
The line of transmission must not be
blocked with metal objects.
To Unlock The Doors And Swing
Gate
Press and release the UNLOCK button on the
RKE transmitter once to unlock the driver's
door or twice to unlock all the doors and swing
gate. When the RKE transmitter UNLOCK but-
ton is pressed, the illuminated entry will initiate,
and the parking lights will flash on twice.
The system can be programmed to unlock all
the doors upon the first RKE transmitter UN-
LOCK button press by using the following pro-
cedure:
1. Press and hold the LOCK button on a pro-
grammed RKE transmitter.
2. Continue to hold the LOCK button for at
least four seconds, but not longer than 10 sec-
onds, then press and hold the RKE transmitter
UNLOCK button.
3. Release both buttons at the same time.
4. Test this feature while outside of the vehicle,
by pressing the LOCK/UNLOCK button on the
RKE transmitter.
NOTE:
Pressing the RKE transmitter LOCK button
while you are in the vehicle will activate the
Vehicle Security Alarm. Opening a door with
the Vehicle Security Alarm activated will
cause the alarm to sound. Press the RKE
transmitter UNLOCK button to deactivate
the Vehicle Security Alarm.
5. If the desired programming was not
achieved or to reactivate this feature, repeat
the above steps.

To Lock The Doors And Swing Gate

Press and release the LOCK button on the RKE
transmitter to lock all doors. The turn signals
will flash to acknowledge the lock signal.
To Turn Off "Flash Lights With
Lock"
NOTE:
The "Flash Lights With Lock" feature can be
turned on or off using the following steps:
1. Press the RKE transmitter UNLOCK button
for 4 to 10 seconds.
2. While the UNLOCK button is pressed, (after
four seconds) press the RKE transmitter LOCK
button. Release both buttons.
3. Test the "Flash Lights With Lock" feature
outside of the vehicle, by pressing the RKE
transmitter LOCK button with the ignition in the
LOCK position, and the key removed.
17