Manual Transmission - If Equipped; Shifting - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 183 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 59AE8F97
/chry_pdm/chrysler/owners/wra/og
The engine block heater must be plugged in at
least one hour to have an adequate warming
effect on the engine.
WARNING!
Remember to disconnect the engine block
heater cord before driving. Damage to the
110-115 Volt AC electrical cord could cause
electrocution.
MANUAL TRANSMISSION — IF
EQUIPPED
WARNING!
You or others could be injured if you leave the
vehicle unattended without having the parking
brake fully applied. The parking brake should
always be applied when the driver is not in the
vehicle, especially on an incline.
CAUTION!
Never drive with your foot resting on the clutch
pedal, or attempt to hold the vehicle on a hill
with the clutch pedal partially engaged, as this
will cause abnormal wear on the clutch.
NOTE:
During cold weather, you may experience
increased effort in shifting until the trans-
mission fluid warms up. This is normal.
art=051701768.tif NO TRANS
Shift Pattern

Shifting

Fully press the clutch pedal before shifting
gears. As you release the clutch pedal, lightly
press the accelerator pedal.
You should always use 1st gear when starting
from a standing position if under heavy load or
when pulling a trailer.
Recommended Vehicle Shift Speeds
To utilize your manual transmission efficiently
for both fuel economy and performance, it
should be upshifted as listed in recommended
shift speed chart. Shift at the vehicle speeds
listed for acceleration. When heavily loaded or
pulling a trailer these recommended up-shift
speeds may not apply.
Manual Transmission Shift Speeds in
MPH (KM/H)
En- 1 to 2 to 3 to
Speeds
gine 2 3 4
3.8L Ac- 15 24 34
cel. (24) (39) (55)
Cruise 10 19 27
(16) (31) (43)
4 to 5 to
5 6
47 56
(76) (90)
37 41
(60) (66)
181