Jeep 2010 Wrangler Owner's Manual page 98

JOBNAME: CHRY OM INTL (Conten PAGE: 98 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 2C856E73
/chry_pdm/chrysler/owners/wra/og
4. If the soft top has been removed, follow
these steps to reinstall the soft top. If the soft
top is on the vehicle, proceed to step #5.
a. If the pivot brackets have been removed,
unzip the sport bar covers and attach the
pivot brackets to the sports bar with the four
screws that were removed using a #T30
Torx head driver. Re-cover and re-zip the
sport bar covers.
art=035605928.tif
b. Lay the soft top into the rear of the vehicle
with the bows pointing forward and the
curved portion of the bows facing upward.
c. Reattach the knuckles onto the metal
pivot brackets.
96
art=035601647.tif
NO TRANS
NOTE:
To aid in reattaching the knuckles, you may
carefully tap on the knuckles using a rubber
mallet.
NO TRANS
d. Screw the pivot screws back into place
using a #T30 Torx head driver. Secure them
until they are snug, being careful not to
cross-thread the screws or overtighten.
art=035601644.tif NO TRANS
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
5. Remove the swing gate bar (black metal bar
for bottom of rear window) and set aside.
NOTE:
Be sure the wire harness in the left rear
corner is not tangled in the soft top bows
before you lift the top.
6. Unsnap and remove the black boot cover.
This cover should be discarded. It was in-
tended as a protective cover for shipping only.