Manual Transmission - If Equipped; Transfer Case - If Equipped; Front/Rear Axle Fluid - Jeep 2010 Wrangler Owner's Manual

Hide thumbs Also See for 2010 Wrangler:
Table of Contents

Advertisement

JOBNAME: CHRY OM INTL (Conten PAGE: 259 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 3A8C38BE
/chry_pdm/chrysler/owners/wra/og
cants, and Genuine Parts" in "Maintaining Your
Vehicle" for further information.
Manual Transmission – If Equipped
Selection of Lubricant
Use
only
manufacturer's
manual transmission fluid. Refer to "Fluids,
Lubricants, and Genuine Parts" in "Maintaining
Your Vehicle" for the correct fluid type.
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 in
(4.76 mm) below the bottom of the hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. Fluid
changes are not necessary unless the lubricant
has become contaminated with water. If con-
taminated with water, the fluid should be
changed immediately.
Transfer Case – If Equipped
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole (A) when the vehicle is in a level
position.
recommended
art=072601793.tif
Adding Fluid
Fluid should be added only at filler hole until
fluid begins to run out of the hole.
Drain
First remove the fill plug (B), then the drain plug
(C). The recommended tightening torque for
the drain and fill plugs is 15 to 25 ft lbs (20 to
34 N·m).
NO TRANS
CAUTION!
When replacing the plugs, do not overtighten
them. You could damage them and cause
them to leak.
Selection of Lubricant
Use only manufacturer's recommended fluid.
Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for the
correct fluid type.

Front/Rear Axle Fluid

Fluid Level Check
Lubricant should be at the bottom edge of the
oil fill hole.
Adding Fluid
Add lubricant only at the fill hole and only to the
level specified above.
Selection of Lubricant
Use only manufacturer's recommended fluid.
Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for the
correct fluid type.
257

Advertisement

Table of Contents
loading

Table of Contents