Replacement Keys; Customer Key Programming; General Information; Vehicle Security Alarm - If Equipped - Jeep 2010 Wrangler Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 17 SESS: 2 OUTPUT: Wed Aug 25 08:13:16 2010 SUM: 52994420
/chry_pdm/chrysler/owners/wra/og
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some after-market remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the keys provided with your new vehicle
have been programmed to the vehicle electron-
ics.

Replacement Keys

NOTE:
Only keys that have been programmed to
the vehicle electronics can be used to start
the vehicle. Once a Sentry Key has been
programmed to a vehicle, it cannot be pro-
grammed to any other vehicle.
CAUTION!
Always remove Sentry Keys from the vehicle
and lock all doors when leaving the vehicle
unattended.
At the time of purchase, the original owner is
provided with a four-digit Personal Identifica-
tion Number (PIN). Keep the PIN in a secure
location. This number is required for authorized
dealer replacement of keys. Duplication of keys
consists of programming a blank key to the
vehicle electronics. A blank key is one which
has never been programmed. See your autho-
rized dealer if you require replacement or ad-
ditional keys for your vehicle.
NOTE:
When having the Sentry Key Immobilizer
system serviced, bring all vehicle keys with
you to the authorized dealer.

Customer Key Programming

See your authorized dealer if you require re-
placement or additional keys for your vehicle.

General Information

The Sentry Key operates on a carrier fre-
quency of 433.92 MHz. The Sentry Key Immo-
bilizer system is subject to the following condi-
tions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM — IF
EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors, hood, swing gate, and ignition for unau-
thorized operation.
If something triggers the alarm, the Vehicle
Security Alarm will sound the horn intermit-
tently, flash the exterior lights, and flash the
Vehicle Security Light in the cluster.

Rearming Of The System

If something triggers the alarm, and no action is
taken to disarm it, the Vehicle Security Alarm
will turn off the horn after 29 seconds, and turn
off all of the visual signals after an additional
31 seconds, then the Vehicle Security Alarm
will rearm itself.

To Arm The System

1. Remove the key from the ignition switch and
exit the vehicle.
15