Adding An Aam (Automated Attendant Module); Adding A Ksu2 (Key Service Unit-2, Second Cabinet) - Comdial DX-80 Installation & Maintenance Manual

Adding an AAM (Automated Attendant Module)

One AAM (Auto Attendant Module) can be added to KSU1. The AA Module adds automated attendant functionality to
the DX-80 system with 10 integrated announcements. (The AAM does not provide voice mail functions.)
Refer to the specific feature description "Automated Attendant" for information
about announcements and programming CO Lines to be answered by the
AAM.
The AAM is installed onto designated connectors located on the CPM.
AAM Installation Procedure
1. Be sure that the entire system is turned off.
2. Remove the KSU cover (four screws at each corner).
3. Connect grounded wrist strap to a suitable earth ground. (If a
grounded wrist strap is not available, bleed any static charge
from your body before touching circuit modules by touching
the gold-painted surface of the inside of the KSU cabinet. If
the KSU is properly grounded this will momentarily discharge
static electricity from your body. NOTE: A GROUNDED
WRIST STRAP IS THE ONLY METHOD OF ASSURING
THAT STATIC ELECTRICITY DOES NOT DAMAGE CIRCUIT
MODULES.)
4. Locate the CPM at the right-hand side of KSU1 above the
408M (and COM4 if installed).
5. Position the AAM over the CPM-AAM connectors as illustrated
in the diagram above.
6. Press firmly (but not forcefully) on the AAM to secure a good connection into the CPM-AAM connectors.
7. Replace KSU cover and secure with cover screws.
8. Restore KSU power.

Adding a KSU2 (Key Service Unit-2, second cabinet)

One KSU2 (Key Service Unit-2) can be added to KSU1. The KSU2 adds:
•
8 (eight) digital DX-80 extension ports
•
4 (four) CO Line ports
•
1 (one) Power Failure Transfer port
•
Extension Expansion connectors for 2 addition DPM8 or 1 APM4
•
Ribbon cable for one APM4
•
Ribbon cable for one COM4
KSU2 is connected to KSU1 via a designated connector located on the CPM inside of KSU1.
KSU2 Installation Procedure
1. Be sure that the entire system is turned off.
2. Remove the KSU cover (four screws at each corner) on both KSU1 and KSU2.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
2-14
M
ANUAL
AAM
CPM