Comdial DX-80 Installation & Maintenance Manual page 214

4. Input the wakeup time in 24 hour format (e.g., 7AM is 0700.)
5. Chose if this alarm time should be set as a one time occurrence or repeated everyday by pressing the
associated LCD Interactive button [one] or [always]. You hear the confirmation tone and the display prompts
for the next extension to program.
6. Input the next extension for which a Wakeup call is to be set. Then press [
Or...
7. Exit Extension Alarm Clock mode (lift/replace handset or press the On/Off button twice.
Operation – Room Status
1. While the Attendant extension is idle, press
2. Input the Attendant extension password. Then press [show]. The display shows:
3. Input the extension for which the Room Status is to be set. Then press [
4. Press the button corresponding to the status in which this extension is to be placed. You hear the
confirmation tone and the extension status is updated. The display prompts for the next extension status for
which Room Status changes are required.
5. Input the next extension to be set. Then press [
Or...
6. Exit Extension Room Status mode (lift/replace handset or press
Conditions
a) If a Release Key is programmed this key can be used to clear any active condition (Extension Alarm Clock
mode, etc. with one touch.)
b) Hotel Enable must be set to "Y" (yes) for these features to operate.
Default Settings
Call Handling – Hotel Enable is set to "N" (no). (Range is Y/N.)
Programming Abstract
To allow the Tenant Attendant to set Room Status and Alarm Clock – Extension features at other system
extensions set the Hotel Enable to "Y."
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
ALARM TIME:07:00
one always
EXTENSION :_
bksp show chg
!7/
PSWD :_
bksp show chg
EXTENSION :_
bksp show chg
EXTENSION :XXX
in out clean
EXTENSION :_
bksp show chg
show
].
3-164
M
ANUAL
show
].
. The display shows:
show
].
the On/Off button
twice).