Wiring Installation; Installing The Ups - Avaya 9130 Installation And Operator's Manual

13. Optional. Insert a rear stop bracket through the inside of each rail
14. Continue to the following section, "Wiring Installation."
Rear Stop Bracket

Wiring Installation

This section explains:
S
S

Installing the UPS

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
NOTE Do not connect the UPS power cord to utility until after installation is completed.
To install the UPS:
1.
Avaya 9130 1000–3000 VA UPS Site Preparation, Installation and Operator's Manual
behind the UPS. Rotate each bracket and slide the bracket until it
fits tightly against the UPS's rear panel. Secure each bracket to the
×
UPS with one M3 8 pan-head screw. See Figure 7.
Repeat for any optional cabinets.
Figure 7. Securing the Back of the Cabinet (Optional)
Installing the UPS, including connecting the UPS internal batteries
Connecting any optional EBMs
Remove the UPS right front cover (behind the LCD control panel).
See Figure 8.
To remove the cover, remove and retain the two screws on the
right side of the cover. Grasp the top and bottom of the cover and
slide the cover to the right.
INSTALLATION
×
M3 8 Pan-Head Screw
S
164201765 Rev 1
23