Installing Communication Options And Control Terminals; Communication Options; Rs-232 And Usb Communication Ports - Avaya 9130 Installation And Operator's Manual

COMMUNICATION

Installing Communication Options and Control Terminals

To install the communication options and control terminals:
1.
2.
3.

Communication Options

The Avaya 9130 has serial communication capabilities through the USB
and RS-232 communication ports or through a connectivity card in the
available communication bay.
The UPS supports two serial communication devices according to the
following table:
Independent
Communication Bay
ConnectUPS-BD Web/SNMP Card
ConnectUPS-BD Web/SNMP Card
NOTE You can configure relays, signal inputs, and the serial port baud rate through the
front panel menus (see Table 3 on page 36).
NOTE The communication speed of the USB port is fixed at 9600 bps.

RS-232 and USB Communication Ports

To establish communication between the UPS and a computer, connect
your computer to one of the UPS communication ports using an
appropriate communication cable (not supplied). See Figure 14 for the
communication port locations.
50
Avaya 9130 1000–3000 VA UPS Site Preparation, Installation and Operator's Manual
Install the appropriate connectivity card and/or necessary cable(s)
and connect the cables to the appropriate location.
See Figure 14 and the following section, "Communication
Options," for detailed information.
Route and tie the cable(s) out of the way.
Continue to "Operation" on page 33 to start up the UPS.
Multiplexed
USB RS-232
Available Not in use
Not in use Available
S
164201765 Rev 1