Paper Feed Service Checks D Service Checks - Toshiba e-STUDIO 16P Service Manual

e-STUDIO 16P
Paper Feed Service Checks Feed Service Checks
Paper Jam Error Indication During POST
FRU
Exit Sensor Flag Flag
Input Paper Feed Sensor
Paper Picks During POST and/or Continuously
FRU
Pick Roller Clutch
Solenoid
Paper Picks but Stops About an Inch Down the Page
FRU
Roller Guides
dication During POST
About an Inch Down the Page
Action
If the exit sensor flag is not resting
within the paper exit sensor during
POST, the printer displays a paper
jam message. Make sure the flag is
operating freely and correctly
installed.
Make sure the input paperfeed
sensor is working properly. A stuck
or incorrectly installed sensor
causes this error.
Action
Check the pick roller clutch for wear.
The solenoid interacts with the
clutch controlling motion of the pick
roller.
If the cam surface of the pick roller
clutch assembly is worn, the bly is worn, the
solenoid may not stop the pick roller
from rotating. Replace the pick roller
clutch assembly if necessary.
Make sure the spring on the solenoid
is properly installed. If the spring is
improperly installed or missing, the
pick roller will continuously pick
paper.
Action
Check for correct position of roller
guides on pick roller assembly.
Diagnostic Information
2-51
mation