Table of Contents
Advertisement
e-STUDIO 16P
Transfer Roll Removal
nsfer Roll Removal
1. Open the front cover and remove the toner cartridge. See
"Front Cover" on page 4-2
2. Release the transfer roll left and right bearing.
3. Remove the transfer roll.
Paper Feed Clutch Solenoid Removal
1. Remove the front cover. See
more information.
2. Remove top cover. See
information.
3. Remove rear auto sheet feed cover. See
(ASF) Assembly Removal" on page 4-3
4. Remove right side cover. See
for more information.
5. Remove controller board cage. See
Removal" on page 4-4
6. Disconnect the printer motor cable.
7. Remove optional Tray 2 connector from bracket.
8. Remove the four main drive gear assembly screws.
9. Remove the main drive gear assembly with drive motor from
printer.
10. Depress paper feed solenoid locking tab and slide paper feed
solenoid off D–roll assembly shaft.
11. Remove the toner cartridge.
12. Tilt the printer carefully to the rear so it is resting on the ASF.
13. Remove the four bottom cover screws.
14. Disconnect paper feed clutch solenoid cable from engine card.
15. Remove the paper feed clutch solenoid.
ch Solenoid Removal
"Top Cover" on page 4-2
for more information.
y 2 connector from bracket.
for more information.
"Front Cover" on page 4-2
"Auto Sheet Feed
for more information.
"Right Side Cover
de Cover" on page 4-3
"Controller Board Cage
Repair Information
pair Information
for
for more
SF.
gine card.
4-7
Advertisement
Table of Contents
