Toshiba e-STUDIO 16P Service Manual page 103

e-STUDIO 16P
Entering Diagnostic Tests Mode
Perform the following steps to enter diagnostics test mode:
1. Turn the printer off.
2. Open the printer cover.
3. Press and hold the operator panel button.
4. Turn the printer on.
5. When the cover open error is indicated on the operator panel
(Error LED on), release the button.
6. Close the cover.
The printer automatically runs the diagnostics test.
•
If the tests pass, the Toner Low
•
If a test fails, a service indication is displayed.
Once the diagnostics test is complete, a one page Quick Test can be
printed by briefly pressing the operator panel button.
3-10
Service Manual
matically runs the diagnostics test.
diagnostics test mode:
Low LED blinks.
Quick Test can be